SALE
NEW

Cloudray Leadshine 3 Phase 3DM683 Stepper Motor Driver 20 60VDC 0.5 8.3A-in Motor Driver from Home Improvement

Scroll to product details, material & care and sizing

$ 56.96

Add to cart Add to wishlist

Term:
microstep, cnc driver, 220v motor, Wholesale cloudray laser, Wholesale dc driver motor, Wholesale 7 2017 case with sunflowers, Wholesale board cnc, Wholesale cnc driver, Wholesale 220v motor, Wholesale clasp hook, Wholesale xfx, Wholesale driver module stepper motor,

Cloudray Leadshine 3 Phase 3DM683 Stepper Motor Driver 20-60VDC 0.5-8.3A Details & Specification :

Item Specifications
Motor Type Stepper Motor
Brand Name Cloudray
Model Number 3DM580
Power Supply DC
Output Current 0.5-8.3A
Supply Voltage 20-60VDC
Logic Signal Current 7-16mA

 

Parameters

3DM683

Min

Typical

Max

Unit

Output Current

0.5

-

8.3 (5.9 RMS)

A

Supply Voltage

+20

-

+60

VDC

Logic Signal Current

7

10

16

mA

Pulse Input Frequency

0

-

200

kHz

Isolation Resistance

500

Suitable Stepper Motors

3-Phase NEMA 23, 34

 

 

 

P1 Function

3DM683 Details

PUL+

Pulse signal: In single pulse (pulse/direction) mode, this input represents pulse signal, effective for each rising edge or falling edge (set by inside jumper J1); 4-5V when PUL-HIGH, 0-0.5V when PUL-LOW. In double pulse mode (pulse/pulse) this input represents clockwise (CW) pulse. For reliable response, pulse width should be longer than 1.5μs. Series connect resistors for current-limiting when +12V or +24V used.

PUL-

DIR+

DIR signal: In single-pulse mode, this signal has low/high voltage levels, representing two directions of motor rotation; in double-pulse mode (set by inside J1 jumper), this signal is counter-clock (CCW) pulse, effective for low level. For reliable motion response, DIR signal should be ahead of PUL signal by 5μs at least. 4-5V when DIR-HIGH, 0-0.5V when DIR-LOW.

DIR-

ENA+

Enable signal: This signal is used for enabling/disabling the driver. High level (NPN control signal, PNP and Differential control signals are on the contrary, namely Low level for enabling.) for enabling the driver and low level for disabling the driver. Usually left UNCONNECTED (ENABLED).

ENA-

 

 

 

P2 Function

3DM683 Details

GND

Power Ground

+Vdc

Power supply, 20~60 VDC, Including voltage fluctuation and EMF voltage.

U

Motor phase U

V

Motor phase V

W

Motor phase W